Airsoft Companion

Toolbox

Discover our practical tools to improve your airsoft experience

AEG, electric, HPA, compressed air

The replica shoots on its own or in a burst of semi

The shooting continues after the relaxation of the relaxation, or the blow goes off in gust.

Verifications
4
Until
Dismantling
Tools
1

Symptoms

  • Replica keeps pulling loose
  • Suddenly, two or three balls leave.
  • Shooting starts from battery connection

Causes

Most common to rare.

  1. Relax that doesn't come back: broken relaxing spring (definition), stuck roomCommon
  2. Relaxing contacts welded between them by sparksPossible
  3. MOSFET (definition) or electronic failurePossible
  4. Cut-off raised worn or misassembled (semi that leaves in gust)Possible

Verifications

0/4

In the order: we start with what does not require anything to disassemble. Check as you go, the list is kept in this browser.

  1. Point the replica to a safe area and unplug. For an HPA (definition), close the bottle and purge the line (definition). Remove the charger before handling.

    Without toolsCaution

  2. Battery disconnected, the trigger must come back frankly alone. Molly or blocked, it maintains contact (definition).

    Without tools

  3. An electronic MOSFET (definition) or HPA may have lost its firing mode. The package leaflet explains the reset, often by keeping the release on the connection.

    Simple tools

  4. Gearbox open: glued contacts are visible to the eye. The cut-off lift (definition) must rotate freely and ascend under the action of its spring; a worn tip no longer cuts the seed.

    DismantlingTools: Precision screwdriver

Stop

Stop and hand over the reply to a technician if:

  • The defect comes from electronics: a MOSFET or a solenoid replaces, it does not repair
  • The problem comes back after winding